Possible Causes And/Or Recommended Solutions - Whirlpool 7WRS22FDBF Instrucciones Para El Usuario

GENERAL OPERATION
Temperature is too warm
Temperature is too cold
Interior moisture buildup
Interior lights do not work
Dispenser lights
do not work
(on some models)
40

Possible Causes and/or Recommended Solutions

New installation - Following installation, allow 24 hours for the refrigerator and freezer to cool
n
completely.
NOTE: Adjusting the temperature control(s) to the coldest setting will not cool either
compartment (refrigerator or freezer) more quickly.
Doors are opened often or not closed completely - This allows warm air to enter the
n
refrigerator. Minimize door openings, keep the doors fully closed, and make sure both doors are
properly sealed.
Air vents are blocked - Remove items that are immediately in front of the vents.
n
Large amount of warm food recently added - Allow several hours for the refrigerator to return
n
to its normal temperature.
Controls are not set correctly for the surrounding conditions - Adjust the controls to a colder
n
setting. Check the temperature again in 24 hours.
Controls are not set correctly for the surrounding conditions - Adjust the controls to a
n
warmer setting. Check the temperature again in 24 hours.
Top refrigerator shelf is colder than lower shelves - On some models, air from the freezer
n
enters the refrigerator compartment through vents near the top refrigerator shelf. As a result, the
top shelf can be slightly colder than lower shelves.
Air vents are blocked - Remove items that are immediately in front of the vents.
n
NOTE: Some moisture buildup is normal. Clean with a soft dry cloth.
Room is humid - A humid environment contributes to moisture buildup. Use the refrigerator only
n
in an indoor location, with as little humidity as possible.
Doors are opened often or not closed completely - This allows humid air to enter the
n
refrigerator. Minimize door openings, keep the doors fully closed, and make sure both doors are
properly sealed.
Doors have been open for an extended period of time - Close the doors to reset the lights.
n
Light bulb is loose in the socket or has burned out - On models with incandescent or full-size
n
LED interior light bulbs, tighten or replace the bulb. See "Lights."
NOTE: On models with mini LED lights, call for assistance or service if the interior lights do not
illuminate when either door is opened. See either the front cover or the Warranty for contact
information.
Dispenser light is turned off - On some models, if the dispenser light is set to OFF, the light will
n
turn on only when a dispenser pad/lever is pressed. If you want the dispenser light to stay on
continuously, select a different setting. See "Water and Ice Dispensers."
Dispenser light is set to AUTO or NIGHT LIGHT - On some models, if the dispenser light is set
n
to AUTO or NIGHT LIGHT, make sure the dispenser light sensor is not blocked. See "Water and
Ice Dispensers."
NOTE: On models with mini LED lights, call for assistance or service if the dispenser lights do not
operate correctly. See either the front cover or the Warranty for contact information.