Klarstein 10031893 Manual Del Usuario página 18

EN
18
1 Do not connect the mains plug yet.
2/3 Undo tank clasps and lift off the top section assembly.
4 Remove contents from inside the tank. Check and identify each component as
listed in fig.1. If anything is missing or damaged please contact your supplier
immediately.
5a Turn the tank upside down and insert the wheels into their positions in the black
base. Retain each castor moulding with the self-tapping screws provided. Make
sure each wheel and base is well fixed.
5b Turn the tank upside down and insert the moulded castor mountings into their
positions in the black base. Retain each castor moulding with the self-tapping
screws provided.
6a For dry suction fit the paper dust bag.
6b For carpet washing or wet suction fit the foam filter.
7 Re-assemble the top to the tank.
8 Fasten the 2 clasps.
9 Attach the suction hose to the suction inlet on the front of the tank.
10 Push the end of the suction hose into the air diffuser handle. Push the end of the air
diffuser handle into the plastic tube. Fit the required accessory to the base of the
plastic tube or directly to the diffuser handle if the plastic tube is not required.
Using the paper dust bag
• Always disconnect the plug from the mains supply before removing the tank cover.
• The filter is made of high quality paper designed to filter small particles of dust. We
Recommend that this filter be used for dry vacuuming only.
• The bag must be completely dry when used to collect dry dust as a wet or damp
bag will clog quickly and be very difficult to clean.
• Check the bag carefully and regularly for tears or small holes. Even a small hole
can cause dust to be exhausted. Never use a bag with holes or tears as this may
cause damage to the motor and invalidate warranty. Replace it immediately.