Warning Information - K Tool International KTI-61201 El Manual Del Propietario

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels
instructions shall be read to and discussed with the operator in the operator's native language by the purchaser/owner or his
designee, making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical
means, but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel
the equipment and its proper use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly
secured loads, overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for
which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
•
Read, study, understand and follow all instructions before using.
•
Inspect the jack stands before each use. Do not use if damaged, altered,
hardware or parts. Make corrections before using the stands.
•
Wear eye protection that meets ANSI Z87.1 and OSHA standards (users and bystanders).
•
Do not use beyond rated capacity. Do not shock load. Maximum load capacity per matched pair shall not exceed the rated
capacity of the individual stand.
•
Use only on a hard level surface capable of supporting the load.
•
Stands are to be used in matched pairs to support one end of a vehicle only. Do not simultaneously support both ends or one
side of a vehicle.
•
Apply the emergency brake, put the gear shift lever in park or in gear if a manual shift transmission, and chock the tires that will
not be lifted off the ground.
•
Center load on saddle. Do not use saddle lugs to support the load.
•
Check the stands for solid contact with the ground and vehicle. Make sure the stands' locking pawls are fully engaging the
support column's teeth.
•
Ensure both stands are set at same height and locking pawls are fully engaged.
•
Do not crawl under vehicle when placing/removing stands.
•
Consult the vehicle manufacturer for the proper frame support locations.
•
This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
•
Failure to heed these warnings may result in personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS
SITUATIONS could cause accidents resulting in serious or fatal personal injury and/or property damage.
WARNING: Indicates a hazardous situation
WARNING
which, if not avoided, could result in death
or serious injury.
in poor condition, or have loose or missing
2
Nov 2016