sunjoe SPX4003-ULT Manual Del Operador página 10

12. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the pressure
washer rating plate. If the power supply is correct, you may
now plug the pressure washer into the power outlet (Fig. 13).
Fig. 13
GFCI
Power light
indicator
NOTE: The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
Operation
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Turn the water supply tap on completely.
2. Release the safety lock, then press the trigger for a few
seconds until the water flow is steady. Operating the
pressure washer in this manner will allow air to escape and
discharge residual pressure in the hose (Figs. 14 and 15).
Fig. 14
Reset
Safety lock
Trigger
Fig. 15
3. Turn the ON/OFF switch (pressure select dial) to the LOW (I)
or HIGH (II) position to start the pressure washer (Fig. 16).
Fig. 16
Using the adjustable spray nozzle
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
1. The spray wand is equipped with an adjustable nozzle.
2. The water pressure can be adjusted to low pressure (–)
and high pressure (+) by turning the pressure adjustment
knob. The nozzle tip can be adjusted from pencil spray
(wide open tip) to fan spray (narrow tip) by turning the
nozzle tip adjustment knob (Fig. 17).
NOTE: When using the unit with detergent, the spray
nozzle has to be set into low pressure and fan spray.
The pressure settings on the spray nozzle are only meant
to work with detergent, it will not affect the overall working
pressure of the unit.
10
STOP
0