Prior To First Use Of Water Dispenser - Beko GNE 60520 DX Manual Del Usuario

The water filter must be removed as
shown in the figure when it is going to
be replaced or when it will no longer
be used and by-pass cover must be
attached. It must be made sure that
Ice Off mode is active before taking it
out.
A
Caution: Water filter cleans some
foreign particles in the water. It does
not purify water from microorganisms.
A
Caution: Ice Off button must always
be pressed during replacement of the
water filter or installing the by-pass
cover.
Prior to first use of Water
Dispenser
C
Water mains pressure must not be
below 1 bar.
C
Water mains pressure must not be
above 8 bars.
C
Pumps must be used in case the
supply water pressure drops below 1
bar or if a jug is going to be used.
C
Water system of the refrigerator
must be connected to the cold water
line. It must not be connected to hot
water line.
C
No water may be obtained in the
initial operation of the refrigerator. This
is caused by the air in the system. To
discharge air from the system, press
Dispenser latch for periods of 1 minute
until water comes from the Dispenser.
Water flow may be irregular in the
beginning. Irregular water flow will be
normalized after the air in the system is
discharged.
C
At the initial startup of the
refrigerator approx.12 hours must pass
before cold water can be obtained.
C
Water mains pressure must be
between 1-8 bars for the operation
of Ice/Water Dispenser smoothly. For
this, check that 1 glass of water (100
cc) can be filled in 10 seconds.
C
The first 10 glasses of water should
not be consumed.
C
Approximately the first 30 cubes
of ice to be obtained from the Ice
Dispenser must not be used.
C
Always use the water filter when a
jug is not being used.
16
EN