Andis CTA-1 Instrucciones De Uso Y Cuidado página 6

clipper. (Figure A). The clipper must be turned
OFF for the battery to charge. The light on the
clipper will fade in and out while charging. When
the clipper is fully charged, the light will stay ON.
The clipper has not been charged at the
factory. Please charge the clipper for
3-5 hours before FIRST use for maximum
performance. When battery is fully charged,
clipper can be used for up to 2 hours of
continuous run time. After first use, clipper
will fully charge in a minimum of 60 minutes.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an
appliance you know is working).
2. Make sure the clipper is turned OFF.
3. Check to make sure adapter cord is plugged firmly into clipper.
4. If failure to charge still exists, return clipper to Andis or an Andis
authorized service station for examination and repair or replacement.
CLIPPER INDICATOR LIGHTS
When the clipper is running in a cordless operation, a white clipper
indicator light (Figure B) means the battery has a strong charge. When the
light turns red, the battery level is low and should be recharged as soon as
possible. If the clipper automatically powers OFF, either charge in the
charging stand or plug in to cord to continue trimming. The clipper
automatically powering off protects the lithium-ion battery and is not a
malfunction. The clipper will resume normal operation when it is recharged
or plugged in to its power cord. The CTA-1 clipper, by design, will run at
full power until the battery is fully depleted. NOTE: If clipper
automatically powers OFF while in use, it may take 1-2 minutes to
resume normal operation after power cord is plugged in.
USING THE ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a longer cut by using any of the attachment
combs made for your Andis clipper. The combs mount easily; simply slide
the cutter blade teeth into comb and slide the comb down. To remove,
simply slide off (Figure C). These attachment combs guide hair into the
blades and give you precise control of hair lengths. The length of trim is
indicated on the attachment comb. Use the chart to find the approximate
6
A