General Safety Regulations; Personal Protective Equipment - Master DH 752 Manual Del Usuario

en - WATER PUMP KIT INSTRUCTION MANUAL
WARNING: CHECK THE COMPATIBILITY OF THE ACCESSORY BEFORE INSTALLATION.

1.GENERAL SAFETY REGULATIONS

The operations required for installation should only be performed by experienced personnel.
The purpose of the manual and all the documentation supplied is to enable both the installer and the operator to perform the in-
stallation, start-up and maintenance of the equipment correctly, without causing damage to the personnel in charge and the item.
All activities related to the operation and maintenance of the unit must be carried out:
•• Only by properly trained people who must adopt safe work practices and use the appropriate PPE for the specific task per-
formed, based on their specific qualification.
•• Only by properly trained persons who have read and fully understood the manuals, technical documents and safety docu-
ments.
•• The use of the device must be denied to anyone who is not adequately trained and competent.
This manual, the technical documents and any attached safety documents must be read and kept for the entire life of the device.
WARNING: This appliance is designed for use in an indoor environment.
WARNING: The pump must not be cleaned using water. To clean the pump, use a damp cloth. Never spray water on the unit
and its electrical components.
The pump must always be kept in a horizontal position, to avoid the accidental release of condensate (water) from the appropri-
ate container It is absolutely forbidden to move the equipment when it is connected to the power socket, as the resulting vibra-
tions and movements could cause the condensed water to escape from the tank affecting the electrical parts.
The pump can be moved only after having emptied the condensate, and in any case it is always necessary to remove the plug
from the socket before moving it.

2.PERSONAL PROTECTIVE EQUIPMENT

For the operations of use and maintenance of the units, use the following personal protection equipment:
CLOTHING: Those who carry out maintenance or work with the unit must wear safety shoes, with non-slip soles in environments
with slippery floors.
GLOVES: During cleaning and maintenance operations, the use of appropriate gloves is required. When recharging the refriger-
ant gas, the use of appropriate gloves is mandatory to avoid the risk of freezing.
MASK AND GOGGLES: During cleaning and maintenance, respiratory protection masks and eye protection goggles must be
used.
WARNING: It is strictly forbidden to remove the safety signs present in the units.
3.INSTALLATION
ATTENTION: Disconnect from the power supply before any operation.
To replace the water tank with the water pump, follow the steps below:
••3.1. Remove the tank (A PIC. 1).
••3.2. Unplug the connector of the infrared switch (B PIC. 2).
••3.3. Remove the metal plate (C PIC. 3).
••3.4. Insert the pump into the compartment (D PIC. 4).
••3.5. Fix the pump on the support plate with the pump bracket and screws (E PIC. 5).
••3.6. Fix the bottom bracket, the condensate hose bracket and condensate hose to the device (F-G PIC. 6).
NOTE: DH 792, it is necessary to connect the pump directly to the device with the hose (F PIC. 6).
••3.7. Then insert the drain pipe into the outlet water of the pump and tie it securely with a binding belt (H PIC. 7).
••3.8. Plug in the connectors to the related sockets (I PIC. 8).
4.HOW TO USE
After installation is completed, close water-tank door, then power on the unit after the drain hose is settled. There are no more
other adjustments required.
5.MAINTENANCE
This water pump kit does not require special maintenance. Keep water tank kit well-stored for next use.