Lubrication; Maintenance Interval - Maruyama QC-HT Manual Del Propietario U Operador

Lubrication

Maintenance Interval

The gearcase and angle drive should be inspect after
each 10 hours of use (only for QC-HT: 20 hours).
Cutting blades should be lubricated at all times.
Lubrication
The gearcase and angle drive should be checked for lu-
brication after each 10 hours of use (only for QC-HT:
20 hours). Grease fittings are installed into both compo-
nents. Use #2 lithiumbase bearing lubricant.
Grease Fitting
for Gearcase
Grease Fitting
for Gearcase
Grease Fitting
for Angle Drive
[QC-HTS]
Light Oil (#10wt.)
Cutting Blade
[QC-HT]
Grease Fitting for
Angle Drive
Light Oil
(#10 wt.)
Grease Fitting
Lubrication of the cutting blades should be maintained
at all times. Use a light oil (#10wt.).
— US-13 —
Grease Fitting
Cutting Blade
[QC-HTR]
Light Oil
(#10 wt.)