Safety Instruction - HIKVISION I0R2401 Guia De Inicio Rapido

type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur)
approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques
de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le
type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une
communication satisfaisante.
This equipment should be installed and operated with a minimum distance 20cm
between the radiator and your body.
Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre
le radiateur et votre corps.
KC
Class B: This device is intended for mainly home use (Class B) and may be used in all
areas.
B 급기기: 이 기기는 가정용(B 급) 전자파적합기기로써 주로 가정에서
사용하는 것을 목적으로 하며,모든 지역에서 사용할 수 있습니다.

Safety Instruction


These instructions are intended to ensure that the user can use the product
correctly to avoid danger or property loss.
Laws and Regulations

The device should be used in compliance with local laws, electrical safety
regulations, and fire prevention regulations.
Electricity

In the use of the product, you must be in strict compliance with the electrical
safety regulations of the nation and region.

The equipment shall not be exposed to dripping or splashing and that no objects
filled with liquids, such as vases, shall be placed on the equipment.

Provide a surge suppressor at the inlet opening of the equipment under special
conditions such as the mountain top, iron tower, and forest.

CAUTION: To reduce the risk of fire, replace only with the same type and rating
of fuse.

The equipment must be connected to an earthed mains socket-outlet.

An appropriate readily accessible disconnect device shall be incorporated
external to the equipment.

An appropriate overcurrent protective device shall be incorporated external to
the equipment, not exceeding the specification of the building.

An all-pole mains switch shall be incorporated in the electrical installation of the
building.

Ensure correct wiring of the terminals for connection to an AC mains supply.

The equipment has been designed, when required, modified for connection to
an IT power distribution system.
Battery

Do not ingest battery. Chemical burn hazard!

This product contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
7