Briggs & Stratton Snapper LT75 Serie Manual Del Operador página 27

Maintenance
4. Move the lift lever to the low cut position (see
Figure 16).
5. Disconnect the lift links from the rear of the mower
deck (see A A and B, F F igure 27).
6. Lower the mower deck to rest on the hard flat sur-
face.
7. Remove the hair pin and adjusting nut from the
front bracket assembly (see C C , Figure 27).
C
A
A D
C
B
8. Adjust link until the adjusting nut fits into the hole
on the front bracket assembly.
9. Assemble washer and hair pin.
10. Reattach rear lift links (see D D and E, Figure 27).
D
B E
E
en
Figure 27
27