Install The Wheels - Briggs & Stratton Snapper LT75 Serie Manual Del Operador

Maintenance

Install the Wheels

If the wheels must be removed for service, make sure
they are installed as follows:
Front Wheel
1. Make sure the valve stem (1) is to the outside (see
Figure 36).
2. Slide the front wheel (2) onto the spindle (3).
3. Fasten the front wheel (2) with washers (4 and 5)
and cotter pin (6). Bend the ends of the cotter pin
apart to keep the front wheel on the spindle.
4. If your model has hub caps (7), install the hub
caps. Make sure the washers hold the hub caps in
place.
5
4
6
7
1
Bag Full Indicator Adjustment
Sliding the carriage bolt, washer, and nut (1) up de-
creases the sensitivity in the bagger before the buzzer
goes off (see F F igure 38). Sliding the carriage bolt,
washer, and nut down increases the sensitivity in the
bagger before the buzzer goes off.
1. Loosen carriage bolt, washer, and nut (1).
2. Slide carriage bolt, washer, and nut up or down the
buzzer lever (2).
3. Tighten carriage bolt, washer, and nut.
NOTE: It may be necessary to change the bag full indi-
cator adjustment as turf conditions change.
32
Rear Wheel
1. Install the washers (1) and spacer (2) onto the axle
(3) (see F F igure 37).
2. Mount the square key (4) in the key slot.
8
9
3. Make sure the valve stem (5) is to the outside.
4. Align the slot in the rear wheel with the square
key.
3
5. Slide the rear wheel (6) onto the axle (2).
6. Fasten the rear wheel (6) with washer (7) and
e-ring (8).
7. If your model has hub caps (9), install the hub
2
caps. Make sure the washer holds the hub caps
in place.
Figure 36
6
1
7
5
2
1
en
1
4
2
2
Figure 37
Figure 38