Electrical Installation - Skymsen PA-7 Manual De Instrucciones

IMPORTANT
Do not operate the equipment when it is placed near a table edge (PICTURE 03).
PICTURE 03

2.1.2 Electrical Installation

Before plugging the equipment on the socket, make sure the network voltage is the same
as indicated on the cord label.
The power plug has 3 (three) pins, the middle one is designed to grounding – Ground Pin.
All the 3 (three) pins must be properly connected before operating the equipment.
The picture shown below indicates the external equipotential connection terminal.
The connection shall be used to make sure that there are no potential differences among
the different equipment connected to the network, avoiding as much as possible electric
shock risks.
The different equipment shall be connected one to the other by means of their
equipotential terminals.
10