ESYLUX PD-C360i/24 DUOplus-FM Manual De Instrucciones página 13

Switch delay
The detector will only activate the lighting after a time delay to prevent
a sudden change in brightness from causing undesired switching on/
off of the lighting.
Time delay from "light to dark": 30 seconds = red LED lights up for
channel 1/green LED lights up for channel 2.
Time delay from "dark to light": 5 minutes = red LED lights up for channel
1/green LED lights up for channel 2.
The "blind" function interrupts the time delay from "light to dark" if the
light value falls below 50 lux and then switches the lighting on at once.
Buttons S1 - S3
The presence detector is equipped with a connection for an external
button for each switching channel. This can be used to manually switch
each switching channel on or off.
Manual switch-on
Briefly press S1 - S3: the lighting will then remain switched on for as long
as the detector detects movement. The predefined time setting will start
once movement is no longer detected. Once this time has elapsed, the
lighting will switch off and the detector will revert to the set operating
mode.
Manual switch-off
Briefly press S1 - S3: the lighting for the respective channel will then
remain switched off for as long as the detector detects movement.
The predefined time setting will start once movement is no longer
detected. Once this time has elapsed, the detector will revert to the
set operating mode.
6 • SETTINGS
DIP switch (fig. 5)
DIP switch 1: "RC"/"manual"
The switch is set to "RC" in the factory settings. This means that the
device can be operated by remote control. The potentiometers are
disabled when the device is in this mode.
When it is set to "manual", settings can be made using the
potentiometers located on the device. The device cannot be operated
by remote control when it is set to "manual".
DIP switch 1
Time setting (light 1 + 2)
• Control: light values in lux
= light value is approx. 5 lux.
For ease of use, the lux scale is graded according to the area of
application:
• passageways
• working areas
• activities requiring a high level
of lighting
Light value 1 Light value 2
= daytime operation
= 1 - 2 (approx. 40 – 200 lux)
= 2 - 3 (approx. 200 – 600 lux)
= > 3 (> 600 lux)
GB
13