Traction Wheel Maintenance; Replacement Of Wheel Ring; Replacement Of The Motor Brush - Pegasolift T14 Guía Para El Uso Y El Mantenimiento

REPLACEMENT OF WHEEL RING

At least once a year it is necessary to control the covering of the polyurethane ring of
the motor wheel, if is necessary to replace it operate as follow:
1) Disconnect the start key (reference page 12 "Instruments" no. 1).
2) Put the truck on safety supports.
3) Remove the rear port.
4) From the under part of the stacker, remove the 8 screws with cylindrical head with
hexagon indicated on the figure with (1).
5) Extract the wheel ring (2) from the body of the motor wheel and replace it with a
new one.
6) Screw again the screws indicated with (1).

REPLACEMENT OF THE MOTOR BRUSH

1
2
6) Screw again the screws of the brush elements (2) to realize a good electric contact.
7) Close the strip covering the brushes.
NOTE: during these operations pay much attention to not let screws, washers or another
material to fall in the interior of the motor.

TRACTION WHEEL MAINTENANCE

2
2
2
Every 500 hours of work is necessary to
control the motor brushes, if they are
exhaust operate as follow:
1) Disconnect the start key (reference page
12 " Instruments" no. 1)
2) Open the cover of the brushes (1).
3) Raise the resort pushing the brush (3)
and extract with care the brush (4).
4) Unscrew the screws for fastening the
elements of the brushes (2)
5) After cleaning with care the area of the
brush-supporting group, introduce the
new brushes checking that the move
freely in their space.
C 22
54
2
1