GE SmartWater GXSS20B Manual Del Propietario Y Instrucciones De Instalación página 19

Problem
Water hard sometimes
Water feels slippery
after installation of
water softening system
Water softening system
not using any salt
Water is blue color
after water softening
system was installed
Water softening system
not regenerating
Cloudiness on glassware
(automatic dishwashers)
Salty tasting water
after installation
Possible Causes
Using hot water while the water
softening system is regenerating
Too few regenerations or more
water being used
Grains of hardness in your water
supply have increased
Absence of hardness minerals
Water softening system is a
"demand" unit
Possible salt bridge
Possible plugged nozzle and venturi
Acidic water in copper plumbing
Meter turbine stuck
Sensor wire corroded
No power to unit
Mechanical defect
Combination of soft water and
too much detergent
Insufficient backwash and
rinse time
Low water pressure
Restricted drain hose
What To Do
• Avoid using hot water during water softening system
regenerations because the water heater will refill with
hard water. See Automatic Hard Water Bypass During
Regeneration section.
• See Regeneration Chart for correct setting.
• Water hardness can change over time, especially in well water.
To check, have the water tested by a water analysis laboratory
or call your local water department. Adjust the timer settings
as needed. See Regeneration Chart .
• This is normal.
•Does not use much salt to regenerate—very efficient.
•See the Operating Instructions, Tips section.
•See the Operating Instructions, Tips section.
•Have the water tested at once.
WARNING: Do not drink the water until problem has
been corrected.
•Call for service.
•Call for service.
•Check the circuit breaker or fuses.
•Call for service.
•This is called etching and is permanent. To prevent this
from happening, use less detergent if you have soft water.
Wash glassware in the shortest cycle that will get them clean.
•Press and hold TOUCH or HOLD button until RECHARGE
starts to flash to start a regeneration.
•At completion of regeneration cycle (approx. 2 hrs) run water
from faucets to purge the salty water.
•Check pressure; should be minimum 20 psi.
•Clean and reconnect hose.
19