Makita LS1016 Manual De Instrucciones página 24

Replacing carbon brushes (Fig. 65 & 66)
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 min-
utes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If elec-
tric brake is not working well, ask your local Makita ser-
vice center for repair.
After use
• After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
• When storing the tool, pull the carriage toward you fully
so that the slide pole is thoroughly inserted into the turn
base.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Steel & Carbide-tipped saw blades
For smooth and precise cutting in
Miter saw blades
various materials.
General purpose blade for fast
Combination and smooth rip, crosscuts and
miters.
For smoother cross grain cuts.
Crosscutting
Slices cleanly against the grain.
For sand-free cuts cleanly against
Fine cross cuts
the grain.
For miters in aluminum, copper,
Non-ferrous metals
brass, tubing, and other non-fer-
miter saw blades
rous metals.
• Vise assembly (Horizontal vise)
• Vertical vise
• Socket wrench 13
• Holder
• Dust bag
• Crown molding stopper set
• Triangular rule
• Dust box
• Hex wrench (For LS1016L)
24