Date & Time Set Procedure; Applying The Cuff - HoMedics Walgreens BPA-450WGN Manual De Instrucciones

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button
located on the side of the monitor.
2. The display will show a blinking number showing
the hour. Change the hour by pressing the
button. Each press will increase the number by one
in a cycling manner. Press the Set button
Original Document Name: AM-LD-01-V6
to confirm the entry, and the screen will show a blink-
ing number representing the minutes.
3. Change the time and date as described in Step 2
above, using the
bers and the Set button
4. A "0" will reappear as the blood pressure monitor is
ready for measurement again.
repeat process to set time and date
again
button to change the num-
to confirm the entries.
Press the button
blinking hour
increasing hour
confirm the entry
13

APPLYING THE CUFF

,
1. If the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the
metal D-ring in order to form a loop.
End of cuff
D-ring
2. Plug the cuff tube into the left side of the unit.
Insert plug here
14