Date & Time Set Procedure; Applying The Cuff - HoMedics BPA-200 Manual De Instrucciones

BPA-200IB_ENGSP.qxd 10/24/05
DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button
located on the back of the monitor.
2. The display will show a blinking number showing
the hour. Change the hour by pressing the
button. Each press will increase the number by one
in a cycling manner. Press the Set button
to confirm the entry, and the screen will show a blink-
ing number representing the minutes.
3. Change the time and date as described in Step 2
above, using the
bers and the Set button
4. A "0" will reappear as the blood pressure monitor is
ready for measurement again.
repeat process to set time and date
11:05 AM Page 13
again
button to change the num-
to confirm the entries.
Press the button
blinking hour
increasing hour
confirm the entry
13

APPLYING THE CUFF

, Please see the illustration below for a description of
the arm cuff.
Index
1. Plug the cuff tube into the left side of the unit.
Insert plug here
Tube
OK Range
Indicator Artery Symbol ( )
14