Initial Commissioning; Use, Operation - HOPPECKE trak HF premium Manual De Instrucciones

NOTE
Risk of damage to connected battery!
A charging cable that is too short or too long can
cause damage to the connected battery.
Consult HOPPECKE Customer Service before
using a charging cable of a different length
or with different conduction properties (e. g.
different cross section)
6.3

Initial commissioning

WARNING
!
Contact with live parts!
Danger to life, or very serious injuries due to
electrocution.
Ensure correct earthing
Use electrical installations and fuses that are
suited to the device properties
Operation in the packaged state is never permissible.
Chargers in the HOPPECKE trak | charger HF premium series are provided
with a 4-pin or 5-pin (red) CEE industrial plug with a power cable for
three-phase mains connection, depending on the power output and
country in question.
NOTE
Make sure that no battery is connected to the
charger when plugging in the power plug!
Once you are sure that the fuse is suitable for the connection values of the
charger, plug the power plug of the charger into an earthed three-phase
socket quickly and completely.
NOTE
Plug in power plug quickly and completely!
If this is not done, the charge current in the input
capacitors of the charger can damage the plug
contacts.
After the boot procedure, which lasts approx. 20 seconds, the charger
display indicates that the device is ready for operation with a blue screen.
Remove the protective film on the multi-colour touch screen.
Setting the time zone
Press the lower right spanner symbol and then the Date & time button to
set the time zone. The device will restart once the time and date have been
confirmed. Time configuration is complete after it has restarted.
Set the language to German or English. Set the desired temperature
unit. The device will restart with the configured language once the new
language has been confirmed. The charger is now ready for charging.
Menu level 0 Standby
Menu level 1 Info
Date &
Menu level 2 Language
time
Menu level 3
7

Use, operation

7.1 Charging
WARNING
!
Contact with live parts!
Contact with battery acid!
Ignition of explosive gases!
Danger to life or very serious injuries.
Follow the DGUV safety instructions for the
charging equipment
Follow the battery operating instructions
Follow the charger operating instructions
Wear acid-proof protective equipment
WARNING
!
Ignition of explosive gases!
Danger to life, or very serious injuries due to
explosion.
Maintain a total ban on smoking, handling
naked lights, fire or open ignition sources
Only charge the batteries in well-ventilated
areas in accordance with EN 50272-3
Avoid generating sparks
- Keep to a minimum distance of 0.5 m
- Press the STOP button to end the charging
process
Settings
Data-
Service Customer
export
Battery Workshop PIN confi-
conditioning charger guration
23