Electrical Connection - Infiniton 75CRGASG56 Manual De Instrucciones

gas pressure conforms to the indications given in table 1 "Nozzle and burner characteristics".
Connection to non-flexible tube
(copper or steel)
Connection to the gas source must be done in such a way as to not create any stress points at any part of
the appliance.
The appliance is fitted with an adjustable, "L" shaped connector and a gasket for the attachment to the gas
supply.
Should this connector have to be turned, the gasket must be replaced (supplied with the appliance).
The feeding connector of the gas to the appliance is threaded 1/2 gas male cylinder.
Connection to flexible steel tube
The gas feed connector to the appliance is a threaded, male 1/2" connector for round gas pipe. Only use
pipes and sealing gaskets that that conform to the standards currently in force. The maximum length of the
flexible pipes must not exceed 2000 mm. Once the connection has been
made,ensure that the flexible metal tube does not touch any moving parts and is not crushed.
Check the Seal
Once the appliance has been installed, make sure all the connections are properly sealed, using a soapy
water solution. Never use a flame.

Electrical Connection

The cooktops fitted with a tripolar electrical supply cord are designed to be be used with alternating current
according to the indications on the rating plate located under the cooktop. The earthing wire can be identified
by its yellow-green colour.
In the case of installation over a built-in electric oven, the electrical connections for the cooktop and oven
should be independent, not only for safety purposes, but also to facilitate removal of one or both in the future.
Electrical Connection for Gas Cooktop
Fit the supply cord with a standard plug for the demand rate indicated on the rating plate or connect it directly
to the electrical mains. In the latter case, a single pole switch must be placed between the appliance and the
mains, with a minimum opening between the contacts of 3 mm in
compliance with current safety codes (the earthing wire must not be interrupted by the switch). The power
supply cord must be positioned so that it does not reach a temperature in excess of 50~C above room
temperature at any point.
Before actual connection make sure that:
The fuse and electrical system can withstand the load required by the appliance;
●
That the electrical supply system is equipped with an efficient earth hook-up according to the norms and
●
regulations prescribed by law;
That the plug or switch are easily accessible.
●
Important: the wires in the mains lead are coloured in accordance with the following code:
Green & Yellow
Blue
Brown
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows: Connect the Green & Yellow wire to terminal marked "E"
- Earth
- Neutral
- Live