Monster semruk S7 V8.1 Manual De Usuario página 32

Fingerprint Sign-In Issues
If at the Windows Hello screen, the Fingerprint reader fails to recognize the fingerprint 3
times it will then block access to the computer. In this case you will need to use your PIN
(the PIN you used when initially setting up the fingerprint reader) to access the computer.
Alternatively you can sign-in using your windows password. After using the PIN code (or
windows Password) to access the computer you can go to the Settings>Accounts>
Sign-in options if you wish to change any settings.
Fingerprint Module Configuration
1. Click the Settings item in the Start Menu.
2. Click Accounts and then click Sign-in options.
3. You will need to add a Windows password (click Add under Password).
4. After you have added the password you will need to also add a PIN.
5. Click Set up under Windows Hello Fingerprint.
6. The wizard will then guide you through the set up process to enroll your
fingerprints.
7. You will be instructed to Touch the fingerprint sensor a number of times
(repeatedly rest your finger on the sensor, and then lift it off until the setup is
complete as instructed).
8. Try to present different parts of your finger in different positions similar to
the various positions you may use when using it, and note the following:
• Hold the finger on the sensor for at least half a second.
• Make sure that you make firm direct contact with the sensor, and cover the
entire area of the sensor with the finger (you are looking for a reading of at
least 75% of the finger area).
• Use a pressing motion as opposed to a touching or tapping motion.
• When authenticating use the same sort of angle you used for enrollment.
9. Click Close when complete.
10. You can choose to Add another finger (this is recommended) or Remove
the current fingerprint reading.
11. You can now touch the fingerprint sensor to log-on to the computer.
Figure 23
Accounts - Sign-in
options
EN
31