System Startup - Monster semruk S7 V8.1 Manual De Usuario

• As the adapter is powered separately, the battery will not be charged, and the
operating system will show the capacity unchanged.
• When the battery is low, and the low battery beep sound is being played,
the system will continue to do so and will not enter a power-saving state.

System Startup

1. Remove all packing materials.
2. Place the computer on a stable surface.
3. Insert the battery and make sure it is locked in position.
4. The AC/DC adapters can be stored in the stand supplied, but can only be
orientated one way as indicated in picture. Insert the adapters with the open
end for the power cord facing the 280W logo. Do not use a single AC/DC
adapter to power the system.
5. When first setting up the computer use the following procedure
(as to safeguard the computer during shipping, the battery will be locked to
not power the system until first connected to the AC/DC adapter and initially
set up as below):
• Attach the AC/DC adapter cords to the DC-In jacks on the rear of the computer
then plug the AC power cords into an outlet, and connect the AC power cords to
the AC/DC adapters and the battery will now be unlocked.
6. Use one hand to raise the lid to a comfortable viewing angle (do not exceed
130 degrees); use the other hand (as illustrated in Figure 1) to support the
base of the computer (Note: Never lift the computer by the lid).
7. Press the power button to turn the computer "on".
Figure 1
Opening the Lid/Computer with Dual AC/DC Adapters Plugged-In
130
0
EN
05