Maintenance Plan; Additional Instructions; Decommissioning And Dismantling - Eurosystems MLT 01 Manual De Uso

Checking the tightness of
fasteners and guards
Cleaning
Inflation
Cable adjustment
Base oil change
Motor
No fuel; top up.
Check the position of the accelerator.
Check that the spark plug cap is properly inserted.
The motor does not
start
Check the conditions of the spark plug and clean or replace if necessary.
Check that the fuel cock is open (only for motor models for which the cock is
provided).
Motor power
Air filter dirty, clean it.
decreases
Wheels are not
Check the transmission cables.
turning
Contact the nearest authorised service centre if the problem cannot be solved.

14. ADDITIONAL INSTRUCTIONS

14.1 DISPOSAL
At the end of its life cycle, the product
must be disposed of in accordance with
the regulations in force for Differentiated
waste disposal and cannot be treated as
simple urban waste.
The product must be disposed of at ded-
icated collection points or must be re-
turned to the dealer if you wish to replace
the product with another new equivalent
product.
The product is composed of non-biode-
gradable parts and substances that can
pollute the surrounding environment if not
properly disposed of. In addition, some of
these materials can be recycled to avoid
environmental pollution. It is everyone's
duty to contribute to the health of the en-
vironment.
When present, the symbol
the electrical and electronic equipment
that must be disposed of separately as

12. MAINTENANCE PLAN

Always before starting the machine - check that there are no untightened
screws, bolts and/or nuts and that the bonnets and protection systems are
intact and correctly fitted.
After each use
As needed
If operation is not as according to the manual
60 hours
See specific manual
13. TROUBLESHOOTING
Possible cause
prescribed by standards 2002/95/EC,
2002/96/EC and 2003/108/EC. Do not
dispose of this equipment in unsorted
municipal waste, but take it to appropriate
separate collection areas.
Ask your local authorities for information
about waste disposal areas.
Anyone who does not dispose of the prod-
uct in accordance with this paragraph is
responsible for it in accordance with the
regulations in force.
14.2 DECOMMISSIONING
AND DISMANTLING
The decommissioning and dismantling of
the Machine and/or the interchangeable
equipment covered by this user's manual
consists in the disassembly of the prod-
uct by authorised personnel in compli-
ance with the provisions of Legislative
Decree 81/08 (use of PPE, etc.) and the
subsequent sorting and disposal as re-
identifies ported in the "DISPOSAL" paragraph of
this Use and maintenance manual.
How often See chapt.
-
11.
10.3
10.1
10.2
See chapt.
7.1.
7.2.
Specific motor
manual
Specific motor
manual
Specific motor
manual
Specific motor
manual
10.1.