Lukas LX-Strut Instrucciones De Uso página 17

WARNING / BEWARE!
On soft surfaces, the pressure area must be enlarged,
to prevent the longwall from sinking.
On slopes, the LX-Strut must be secured with pegs.
Illustration shows FAP4040 available www.stablox.de
LUKAS Operating Instructions LX-Strut
WARNING / BEWARE!
The LX-Strut stabilisation system is not explosion-proof!
When using the LX-Strut in potentially explosive atmospheres, it must be
excluded that:
- the system will cause an explosion.
- an explosion could be triggered by working with the device.
e.g. a spark could be generated by extending the strut. The responsibility for
the explosion prevention or the exclusion of the work with the LX-Strut lies
with the operator of the working device and / or the responsible person at the
place of employment.
When working in potentially explosive areas, all valid national and international
legal regulations, standards and safety rules for
WARNING / BEWARE!
The LX-Strut should not come into contact with acids or alkaline
substances
The light grey plastic components of the LX Strut are, dependent on the
conditions, resistant to
Glycol - Water 1: 1 mixture / ethanol-technically pure / acetone-technical pure /
AdBlue® - commercial / gasoline E85 - commercially available.
After prolonged exposure, weight and dimensional changes are possible, but
are strongly dependent on the duration of exposure. Irreversible changes in
properties are possible. If in doubt, the components should be renewed for
safety reasons.
If this is unavoidable, clean the device immediately afterwards. Do not use
cleaning agents or high pressure cleaners to clean the LX-STRUT.
LUKAS Operating Instructions LX-Strut
32 33