Clarke FloorCrafter 07104A Manual Del Operador página 12

ENGLISH
EN
How to Operate the Machine
6. When contact wheel is fully engaged with the surface,
gradually adjust your pace for adequate fi nish removal.
Keep sander in motion while the contact wheel is
engaged with the surface or dwell marks will occur.
7. Move the machine in the direction of the grain in the wood
whenever it is possible. Sand the surface at a constant
pace.
8. Gradually feather-cut out at the termination point by
easing the contact wheel up with the control lever. (See
Figure 13)
9. Repeat technique described in steps 5, 6, 7, and 8 and
sand back down pass just made. When completed, begin
a new pass by overlapping previous pass half the width
of the abrasive. Stagger termination points to prevent a
distinct ridge and a better blend when edging.
10. Empty contents of the dust bag into a metal container
located outside the building. Dust bag should be emptied
whenever full, as indicated on bag.
WARNING: Do not overfi ll dust bag or serious
fi re may result. Never leave a dust
bag containing dust unattended.
Sanding dust can self ignite and
cause a fi re or explosion. Use only
genuine Clarke American Sanders
replacement bags.
CAUTION: An overfi lled dust bag may effect
machine balance and performance.
Do not handle or disturb dust bag
and elbow while sanding or damage
to the fl oor may occur.
-12-
Figure 13
®
Clarke American Sanders Operator's Manual (EN) - Floorcrafter