Clarke FloorCrafter 07104A Manual Del Operador página 4

ENGLISH
EN
DANGER: Operating partially assembled sanding equipment could result in injury to the operator or bystander and could
cause damage to the equipment or to other property.
• Do not operate this equipment unless it is fully assembled and all guards, doors and covers are secured.
• Keep all fasteners tight.
• Keep all adjustments within manufacturers specifi cations.
DANGER: Moving parts on this sanding equipment can cause injury to the operator or bystanders.
• Keep hands, feet and loose clothing away from all moving parts.
• Do not change or adjust the abrasive while the sanding equipment is running.
• Do not service the sanding equipment while it is running.
DANGER: This sanding equipment requires a supply of electricity. Improper use could result in electrical shock or fi re.
• Connect only to an electrical source matching what is shown on the equipment nameplate.
• Do not use this sanding equipment on an ungrounded electrical circuit. Consult an electrician if you suspect the
circuit is not properly grounded.
• Do not use this sanding equipment with a damaged electrical cord. Inspect before each use.
• Avoid striking the electrical cord with the abrasive. Always lift the electrical cord over the sanding equipment.
• Do not use the electrical cord to move the sanding equipment.
• Disconnect the electrical source before servicing this equipment.
WARNING: In the event of a bag fi re, injury can occur to the operator if the operator is tied or strapped to equipment. Use operat-
ing belt properly (follow procedure on page 11).
WARNING: Injury to the operator or bystander can occur if protective gear is not worn while sanding. Always use eye, ear, and
respiratory protection while performing any sanding operation.
WARNING: Bodily injury could occur if power is applied to the equipment with the power switch already in the "ON" position.
Always check to assure that the power switch is in the "OFF" position before connecting power supply.
CAUTION: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and
repairs performed by unauthorized personnel will void your warranty. Servicing of this unit must always be referred
to an authorized Clarke American Sanders distributor.
CAUTION: Use of this equipment to move other objects or to climb on could result in injury or damage. Do not use this equip-
ment as a step or furniture. Do not ride on this equipment.
CAUTION: Damage could occur to the equipment if not properly kept in a dry building for storage. Store the equipment in a
dry building.
CAUTION: The equipment is heavy. When transporting the equipment, remove the motor. Get help to lift the equipment and
motor.
CAUTION: Serious damage to the fl oor can occur if the sanding equipment is left running in one spot while the sanding drum
is in contact with the fl oor. To avoid damage to the fl oor, feather cut in at a normal sanding rate. Do not dwell while
lowering or raising the contact wheel. Always sand at a constant rate.
-4-
®
Clarke American Sanders Operator's Manual (EN) - Floorcrafter