Fitting The Handlebar - BH FITNESS H-916 Instrucciones De Montaje Y Utilización

4.- FITTING THE HANDLEBAR

Position the handlebar (B) on the
handlebar stem (C), Fig 5, tighten the
knob (V) and then insert the handlebar
stem (C) into the hole on the main
body (A), Fig 5. Position it correctly
and then tighten knob (Y) by turning it
clockwise.
ADJUSTING THE HANDLEBAR
HORIZONTALLY
Position the handlebar (B) at a
comfortable distance
exercise but without going beyond the
"MAX" marks, now tighten knob (V)
securely, Fig 5.
ADJUSTING THE HANDLEBAR
VERTICALLY
Position the handlebar (B) at a
comfortable distance
exercise but without going beyond the
"MAX" marks, now tighten knob (Y)
securely, Fig 5.
5.- ATTACHING THE
MONITOR
Fit the monitor (m), Fig 6, into the
bracket (n). Take the middle cable and
connect terminal (h) to terminal (k),
coming out of the bottom of the main
body (A). Insert the jack on the
middle cable into the back of the
monitor (See the instruction book for
the monitor).
EXERTION SETTINGS
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control (Z),
located on the stem of the main body
(A), Fig 7. This provides various
exertion settings
clockwise.
for doing
for doing
when turned
To increase pedal resistance turn the
tensioning control (Z) clockwise (+)
until the exertion level best suits your
exercise requirements.
To reduce pedal resistance turn the
tensioning control (Z) anticlockwise (-).
During exercise the flywheel will get
hot due to the braking effect, so when
you have finished exercising it is
advisable to set the tensioning control
(Z) to minimum in order to help stop
the brake shoe from hardening.
Important:
This tensioning control (Z) is equipped
with an emergency braking system
which, when applied with force (as
shown by the arrow in Fig 7),
produces a much sharper braking
effect.
LEVELLING.
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (13) up or down, as
shown in Figure 7.
MOVEMENT & STORAGE
The unit is equipped with wheels (15)
Fig (7) , to make it easier to move.
The wheels located at the front of your
unit make it easier to move it into a
chosen position, by lifting the rear of
the unit up slightly and pushing it, as
shown in Figure 8. Store your unit in a
dry place, preferably not subject to
changes in temperature.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
10