Conversion Of The Appliance (Installer); Maintenance (Installer) - Klarstein Illuminosa Manual Del Usuario

CONVERSION OF THE APPLIANCE (INSTALLER)

Changing the injectors
• The burners can be adapted to different types of gas by simply installing the
injectors suitable for the gas you want to use. The "kit injectors" can be supplied
together with the appliance or purchased.
• To do this, first remove the burner cups and with a socket spanner, unscrew injectors
using proper tool and replace them with injectors corresponding to the new
adjustment gas type. Always tightly lock the injector in place, without adding any
material on the injector's threads: It is forbidden!
• To help the installer, there is a table in the "Technical Data" section giving nominal
heat input, injector diameter and operating pressures of the different types of gas.
For best comprehension, each injector is marked on its body with proper diameter.
• After the injectors have been changed, the technician must adjust the burners as
described in the previous paragraphs. Seal any adjustment or preadjustment parts.
Important note: After the conversion, substitute the adjustment sticker data plate
put on the bottom of the appliance with the new one, corresponding to the new gas
adjustment. The sticker is included in the "kit injectors".

MAINTENANCE (INSTALLER)

Note: Prior to any maintenance work or before changing parts, disconnect the
appliance from the gas and electricity power sources.
Replacing components
• To access the terminal board and the power cable, it is necessary to remove the
hob from the cabinet by unscrewing the relative fixing screws (V) (see figure 7).
• If the power cord needs to be replaced, contact customer service or a similarly
qualified person as it is necessary to use special utensils. The technician will have to
connect a cable with a suitable cross section keeping the earth wire longer than the
phase wires.
• To replace other gas and electrical components, that are lodged inside the hob, it is
enough to remove the work top unscrewing the fixing screws of the burners.
• Replace the seal each time you change a tap in order to guarantee a perfect
tightness between body and rail.
EN
39