Cequent Performance Products 76084 Instrucciones De Instalación página 4

1. REMOVE PLASTIC PLUGS: Remove (3) plastic plugs from existing holes
in frame rails and return to owner, use flat headed screw if necessary.
Each side. Return to owner.
3. INSTALL FASTENERS: Rear fasteners - Feed coiled end of pull wire through
rearmost hole in frame and out access hole (forward hole). Slide spacer (item
2) over coiled end of pull wire and attach carriage bolt (item 1). Feed spacer
then carriage bolt into access hole and out rearmost hole. See figure 2. Both
sides. Forward fasteners - Attach carriage bolt (item 1) to pull wire and slide
spacer (item 2) onto pull wire. Insert carriage bolt into forward most access
hole then insert spacer then pull back out access hole. See figure 3. Leave
pull wires attached.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. LOWER EXHAUST: Lower exhaust system at the (3) rubber isolators. Note:
Spraying a lubricant on the metal hanger rod and the rubber isolator helps with
removal. Pry bar or exhaust hanger tool may be helpful.
4. RAISE HITCH : Raise hitch into position, feed pull wire through corresponding
slots on hitch with spacer (item 5) (see figure 4 for orientation) between frame and
hitch bracket at forward attachment as shown. See figure 1. Install conical washer
and use to hold the bolt in place, remove the pull wires and attach the hex nut.
Tighten to hold hitch in place, repeat on all fasteners.
Sheet 4 of 15 76084NP
⑤
10-31-16 Rev. B