Cequent Performance Products 24944 Instrucciones De Instalación página 4

1. Remove (3) plastic underbody panels – using a flat head screw
driver, remove (14) plastic push-type rivets and (3) threaded panel
fasteners from bottom panels.
2b. Lower Fascia removal - using a plastic trim panel tool, remove (5)
clips holding wiring harness to fascia retaining tabs.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
2a. Lower Fascia removal - using a Phillips head screw driver,
remove (2) screws located at bottom outer edge of lower fascia, (1)
per side.
2c. Lower Fascia removal - using a plastic trim panel tool, gently
remove the plastic fascia starting at the outer edges.
Sheet 4 of 18 24944NP 10-25-16 Rev. B