Cequent Performance Products 24945 Instrucciones De Instalación página 4

1. Remove (2) plastic underbody panels – using an 8mm socket,
remove (5) screws and a 10mm socket, remove (1) plastic nut from
bottom panels, both sides. NOTE: Carefully remove the (3) clips
holding wire harness to the driver's side panel.
3a. Remove fascia - using an 8mm socket , remove (2) screws from
wheel well, both sides.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Remove taillights – Open trunk. Using a flat head screw driver,
remove (1) plastic screw from each panel covering the taillight
mounting hardware. Using a 10mm socket, remove the (2) hex nuts
from taillights and gently pull the taillights rearward. Disconnect the
wiring from taillights.
3b. Remove fascia - using a T15 torx bit, remove (1) screw located
vertically in the upper area of wheel well (both sides), and (3) screws at
rear of fascia.
Sheet 4 of 21 24945NP 4-26-16 Rev. A