Cequent Performance Products 24945 Instrucciones De Instalación página 5

3c. Remove fascia - using a 10mm socket, remove (2) screws from
top of fascia near trunk, (1) per side.
4. Unplug rear sensor (if equipped) – on some models, disconnect
wiring harness from rear sensor or temporarily remove sensor from
bumper beam.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
3d. Remove fascia - using a plastic trim panel tool, gently remove the
plastic fascia starting at the outer edges.
5. Remove bumper beam – using an 18mm deep wall socket with 6"
extension, remove (4) flange hex nuts holding bumper beam to end
panel.
Sheet 5 of 21 24945NP 4-26-16 Rev. A