Pit Boss PRO Serie Manual Del Usuario página 17

MPC MP1 MP2
MP2
MP2 MP3
MP3
2 MP3
P2 MP3
MP3
MP3
MP3
PC MP1
MP1
P1 MP2
MP2 MP3
The central readout displays both the Actual and Set temperatures. The Actual temperature is constantly
displayed unless the Set temperature is being adjusted. The Actual temperature is the temperature
from inside the Main Barrel. The Actual temperature readout is taken by the grill probe (sensor) from
the inside of the grill barrel.
MP3
To show the Set temperature, press the Controller Knob. The Set temperature is active when the readout
is blinking. To adjust the Set temperature, rotate the Controller Knob, as needed. Once the desired Set
temperature is reached, press the Controller Knob to confirm the Set temperature, then the readout will
return back to the Actual Temperature.
Press the button once to activate the Recipe Steps. There are nine Recipe Steps available to set. Adjust
the settings of each Recipe Step by using the Controller Knob.
Displays the current Recipe Step.
MP3
Displays the Time set during the Recipe Step. Press the Recipe Button to activate the Recipe settings.
Use the Controller Knob to switch through the Recipe Steps, one being the Time.
Displays the Actual and Set temperature of the Programmable Meat Probe - which is the first Meat
Probe plug-in port (MPC). The Actual temperature is constantly displayed unless the Set temperature
is being adjusted. When the MPC Button is pressed, the selected Meat Probe readout will blink and the
Set temperature can be adjusted. When not in use, disconnect the Meat Probe from the connection port
and code "noP" will be displayed. Compatible with Pit Boss® Grills branded meat probes only.
Displays the Actual temperature of a Meat Probe. These three Meat Probe readouts correspond with
the plug-in connection port selected. When not in use, disconnect the Meat Probe from the connection
port and code "noP" will be displayed. Compatible with Pit Boss® Grills branded meat probes only.
This readout is displayed after Power-down has been selected. It indicates that the automatic cool-
down cycle has started. Once the cool-down cycle is completed, the readout will no longer be visible.
The FAN icon is visible when the fan is in operation. When the central readout has an error code (Err)
and the FAN icon is blinking, the Fan is not working. See the section on troubleshooting for assistance.
The AUGER icon is visible when the auger is turning. When the central readout has an error code (Err) and
the AUGER icon is blinking, the auger is not working. See the section on troubleshooting for assistance.
The IGNITOR icon is visible when the ignitor is in use. When the central readout has an error code (Err)
and the IGNITOR icon is blinking, the ignitor is not working. See the section on troubleshooting for
assistance.
When the central readout has an error code (Err) and the PELLET icon is visible, the fire in the fire pot has
gone out or the hopper may be empty. See the section on troubleshooting for assistance.
MP2
MP2 MP3
MP3
MP3
17