Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Aire acondicionado para barcos y yates
3.14 Electric Box Installation
Mount the electric box using four M5 screws.
Mount the electric box in a cool dry location and leave plenty of room for maintenance.
3.15 Installation Checklist (Review Prior To Installation)
3.15.1 Seawater cooling system:
Speed scoop located as far below the water line and as close to the keel as possible
◆
Shut off valve (sea cock) and speed scoop properly sealed and tightened
◆
Seawater pump is at least 1' (305mm) below water line and securely mounted
◆
Strainer mounted below pump with access to filter
◆
Double/reversed stainless steel hose clamps on all hose connections
◆
Teflon tape on all threaded connections
◆
Hose runs uphill from speed scoop and sea cock to strainer, pump and a/c unit, then downhill
◆
(if possible) from a/c unit to overboard discharge
Water flowing freely from overboard discharge while pump is running
◆
Pump relay panel, if used, must have its own circuit breaker sized for the pump (20 amp max)
◆
All metal fittings should be bonded
◆
3.15.2 Mounting
Not in engine room or bilge area, must be sealed away from exhaust or fumes
◆
Proper spacing allowed around unit
◆
Attached to solid level platform with hold down brackets provided
◆
Condensate drain routed aft and down hill to a sealed sump (not bilge)
◆
All penetrations to bilge area sealed
◆
Blower rotated toward supply air grille
◆
3.15.3 Electrical
All butt connections on pumps are tightly crimped and covered with heat shrink
◆
12
Publicidad
Tabla de contenido
