Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEAMING
1. Place garment on a clean, rust-free clothes hanger. Hang from clothes hanger hook located on
Pole Top.
2. Point Steam Nozzle at bottom of garment, then press and hold Steam Button (Steam-Lock Switch
may also be used - refer to Page 11 for details). Steam will rise along inside and outside of
fabric, removing wrinkles. Slowly slide Nozzle vertically, from bottom to top of garment.
NOTE: For best results, hold Steam Nozzle within 1/2 inch or directly against fabric.
3. Release Steam Button to stop steam flow, then smooth fabric with your free hand.
4. Repeat STEPS 2 & 3 as necessary until fabric is smooth and wrinkle free.
NOTE: Steaming fabric is ideal for quick touch-ups; refreshing garments, smoothing minor
wrinkles, etc. For eliminating major wrinkles or creating creases, the Ironing Plate should
be used. Refer to section below for details.
IRONING
For removing especially stubborn wrinkles and creating crisp creases, the heated Ironing Plate is
recommended. A folded towel placed on a flat heat/moisture resistant surface may be used if an
ironing board is not readily available. For ironing smaller areas (such as a shirt cuff), the included
Press Pad may be used.
NOTE: It is NOT RECOMMENDED to press on any surface, such as wood, that may be
damaged by heat and moisture.
1. If connected, remove Fabric/Lint Brush before proceeding.
CAUTION: In order to prevent burns or other injury, the Fabric/Lint Brush should only be
removed when Ironing Plate has been allowed to fully cool (at least 30 minutes).
2. If necessary, allow Ironing Plate to heat up (Heating Indicator Light will turn off when ready).
3. Place fabric on ironing board or folded towel, and press down on it with Ironing Plate. Smoothly
move Plate over entire fabric while applying pressure, as you would with a regular iron. To make
a crease, fold fabric and apply Ironing Plate. Steam Button may be pressed any time steam is
desired.
CAUTION: As with any iron, do not let the hot Ironing Plate rest in one spot on any fabric
for an extended period of time. This may result in damage to the fabric.
4. To use Press Pad, slide your hand through the velcro strap on back. The Press Pad will protect
your hand from hot steam and the Ironing Plate. While supporting fabric with the Press Pad,
press it firmly between the Ironing Plate and Pad to smooth wrinkles and create creases.
12
U
SING THE
2-
-1 F
IN
ABRIC
Top Innovations, Inc.
S
& I
TEAMER
RON
Publicidad
Tabla de contenido
