Top Innovations SteamFast SF-434 Manual De Instrucciones página 9

2- -1 F
IN
CONNECTING NOZZLE STATION & CORD CLASP
NOTE: These instructions assume Telescopic Pole is fully extended when attaching Nozzle
Station and Cord Clasp. Refer to Page 7 for details on adjusting the length of Telescopic Pole.
NOZZLE STATION
1. Attach Nozzle Holder to Nozzle Station:
• Align three pegs on back of Nozzle Holder with holes on Nozzle Station.
• Insert bottom peg of Nozzle Holder into lower hole on Nozzle Station.
• While squeezing in on sides of Nozzle Holder, swing top of Holder inward and insert top two
pegs into upper holes as shown (FIGURE 5-A).
2. Connect assembled Nozzle Station to Telescopic Pole, using Station's two grips. Open clasp on
top grip, then press Nozzle Station onto SECTION 2 of Telescopic Pole (FIGURE 5-B).
NOTE: Nozzle Station will only fit correctly on SECTION 2 of Telescopic Pole. For proper
unit balance, make sure Nozzle Station faces towards rear of unit.
3. Once connected, close clasp on top grip to secure Nozzle Station to Telescopic Pole. Nozzle
Station will slide down and rest on top of SECTION 2 Extension Lock.
CORD CLASP
1. Connect Cord Clasp to SECTION 4 of Telescopic Pole, by pressing grip onto Pole (FIGURE 5-C).
NOTE: Cord Clasp will only fit correctly on SECTION 4 of Telescopic Pole. For
convenience, Cord Clasp should face towards rear of unit - this will make it easier to insert
power cord when storing.
2. To use Cord Clasp, open hinged clasp. Insert bundled power cord, then lock clasp back into
closed position.
A
A
SSEMBLING THE
S
ABRIC TEAMER
FIGURE 5
Top Innovations, Inc.
& I
RON
B C
9