Top Innovations SteamFast SF-434 Manual De Instrucciones página 13

C
ARE
PROPER STORAGE
Preparing your 2-in-1 Fabric Steamer & Iron for storage is quick and simple. When you have
finished with your unit, follow the steps listed below.
1. Set Lighted On/Off Switch to "OFF" position. Unplug power cord from electrical outlet.
2. Remove Water Tank Lid from Water Tank, then empty any remaining water into a sink or tub.
Replace Water Tank Lid.
NOTE: It is not necessary to empty Water Tank after each use if you do not wish. However,
it is recommended that it be drained for storage and filled with fresh distilled water for each
use.
3. For storage convenience, you may wish to collapse Telescopic Pole to its most compact height
(refer to Page 8 for details).
4. Bundle power cord and secure in Cord Clasp (refer to Page 9 for details).
5. Store 2-in-1 Fabric Steamer & Iron in a cool dry location.
SELF-CLEANING
A common maintenance need for steam appliances is the removal of build-up caused by high
mineral content in many municipal water supplies. This mineral build-up may limit the
effectiveness and reduce the life of your 2-in-1 Fabric Steamer & Iron.
The best way to minimize mineral build-up is to use distilled or de-mineralized water when
using your 2-in-1 Fabric Steamer & Iron. In addition, the unit incorporates a convenient self-
cleaning feature, which uses high-pressure water to flush mineral deposits out of the Steam Nozzle.
Using distilled water in conjunction with regular self-cleaning will extend the life of your 2-in-1
Fabric Steamer & Iron, and keep it functioning at its maximum potential.
NOTE: It is recommended that the following procedure be followed once every 3-4 uses.
1. Make sure Water Tank is filled with at least 16 oz. (473 ml.) of distilled or de-mineralized water.
2. If unit is already powered on and heated, proceed to Step 3. If not, plug power cord into a
convenient electrical outlet. Set Lighted On/Off Switch to "ON" position, then wait for Heating
Indicator Light to turn off.
3. Set Self-Clean Switch on back of unit to "ON" position (for normal unit operation, it should
always be set to "OFF").
4. Hold Steam Nozzle over a sink or tub, and press Steam Button. The Steam Nozzle will begin
emitting a powerful burst of steam. After several seconds, it will begin spraying water as well.
CAUTION: To avoid burns or other injury, use care when operating unit in self-clean mode,
as water sprayed by Steam Nozzle is hot. Be sure Steam Nozzle is pointed in a safe
direction, away from yourself, other people, pets or plants.
5. Allow unit to continue cleaning for at least 2 minutes. More time may be necessary if unit has
not been cleaned for a long period.
6. Once cleaning is complete, release Steam Button, then set Self-Clean Switch back to "OFF"
position. Follow Proper Storage procedure above.
& S G
TORAGE UIDELINES
Top Innovations, Inc. 13