Top Innovations SteamFast SF-434 Manual De Instrucciones página 8

ADJUSTING TELESCOPIC POLE
In order to adjust the length of SECTIONS 1, 2 & 3 of the
Telescopic Pole:
1. Release Extension Lock directly below SECTION 1 by
swinging hinge outward as shown. The SECTION 1 above
it can then be extended / retracted (FIGURE 3).
2. Once SECTION 1 is at desired length, close hinge to
once again secure Extension Lock.
3. Repeat STEPS 1 & 2 for SECTIONS 2 & 3 of the
Telescopic Pole, using the Extension Lock directly below
each of those sections.
CONNECTING POLE TOP
NOTE: Make sure that SECTION 1 of Telescopic Pole is
extended at least 6 inches (refer to Page 7 for details).
1. Align Pole Top with end of SECTION 1. Make sure that guide
ribs inside Pole Top align with grooves on sides of SECTION 1
(FIGURE 4-A).
2. Slide Pole Top onto top of SECTION 1. Press firmly down on
Pole Top to seat it securely in place (FIGURE 4-B).
NOTE: When connecting or removing Pole Top, never
rotate it. Doing so may break guide ribs inside, preventing
Pole Top from seating firmly on Telescopic Pole. Always
slide Pole Top straight up and down.
8
A
SSEMBLING THE
2- -1 F
IN ABRIC
Top Innovations, Inc.
S & I
TEAMER RON
FIGURE 3
A
B
FIGURE 4