Top Innovations SteamFast SF-434 Manual De Instrucciones página 4

IMPORTANT SAFETY INSTRUCTIONS
11. If Lighted On/Off Switch does not illuminate when set to "On" position, unit is not operating
normally. Immediately turn unit off and disconnect from power supply, then refer to
troubleshooting guide on Page 14 of this manual for assistance.
12. Always turn off unit and unplug power cord when not in use.
13. Do not use unit outdoors or operate where aerosol (spray) products are being used, or where
oxygen is being administered.
14. Unit is only meant to be used with recommended SF-434 accessories. Using other types of
attachments may cause damage to unit or injury.
15. When filling Water Tank, only distilled or de-mineralized water should be used in unit, in order
to minimize potential build-up of mineral deposits. Other cleaning agents could damage unit or
cause injury. Do not overfill unit.
16. Do not attempt to use steam without first properly filling Water Tank.
17. To reduce risk of contact with hot water emitting from steam vents, check appliance before each
use by holding Steam Nozzle away from body and pressing Steam Button. Do not operate unit
if steam vents are blocked.
18. Burns can occur from touching hot metal parts, hot water, or steam. Do not touch Ironing Plate
while unit is in use. Do not turn unit upside-down - it may contain hot water.
19. When pressing/steaming any item for the first time, it is recommended that you consult the
manufacturer's guidelines for material being steamed. For items in question, test on an
inconspicuous area before proceeding.
20. Do not allow power cord to touch hot surfaces during use. Bundle cord inside Cord Clasp when
storing.
21. Always allow 2-in-1 Fabric Steamer & Iron to cool completely (at least 30 minutes) before
storing.
Use of this appliance for anything other than its intended purposes as specified in this
manual may result in voidance of the warranty.
SAVE THESE INSTRUCTIONS!
4
FOR HOUSEHOLD USE ONLY
Top Innovations, Inc.