Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
Display (See §. 2.3).
2
Range key: operative in VAC, VDC, VLOWZ, Ω, C, AAC, ADC ranges.
Yellow key: MODE AC/DC
The AC mode is selected (default) on V and DC is selected (default) on A.
• Switch to AC or DC mode by briefly pressing the same key (short beep).
3
• The current mode is displayed on the LCD.
• To disable the sleep mode: hold down
while turning the meter on.
• Sleep mode is disabled and symbol
(permanent) won't display any
longer.
Hold key:
• Holds the display on the current value and freezes it (short press).
4
• A second short press returns the multimeter to normal mode.
• This key is operative in all ranges (excepted NCV).
5
OFF: power is off.
6
NCV: Non Contact Voltage Detection (230V) 50 Hz
7
VLowZ: Low impedance voltage measurement, AC
8
V AC/DC: voltage measurement (10MΩ), AC or DC
9
T: TK-thermocouple temperature measurement, in °C or in °F
10 OHM/CONTINUITY/DIODE/CAPACITANCE:
11 A: current measurement in A, AC or DC
12 mA: current measurement in mA, AC or DC
22
13 μA: current measurement in μA, AC or DC
14 Input terminal for AC and DC current measurement to 10A
15 Common (return) terminal for all measurements
Input terminal for voltage, resistance, continuity, diode, capacitance, and
16
temperature measurements
Input terminal for AC and DC microamps and milliamp measurements to
17
600mA
Default Auto-range.
2.3 Display
Item
Description
Item
Description
1
Display Hold is enabled
7
F Farads for capacitance
2
AC, DC voltage or current
8
n, m, μ decimal prefix
3
Diode test is selected
9
°F, °C temperature
4
Continuity is selected
10
Autoshutdown is enabled.
Battery is low and should
5
M, k – decimal prefix
11
be changed.
6
A, V – amps or volts
12
Auto measurement
2.4 Fixation and stand
The meter can be used in different positions for a convenient and good reading:
1. on the table
2. on a metallic door with our magnet-soft sheath
3. with the stand
23
Publicidad
Tabla de contenido
