Sauder Carson Forge Serie Manual Del Usuario página 12

Step 6
Fasten the ACCENT CORNERS (8E) to the END MOLDINGS (AA and BB). Use two SILVER 5/8" MACHINE SCREWS (15S).
å
Fasten the MOLDINGS (Z, AA, and BB) to the ENDS (A and B). Tighten eight HIDDEN CAMS.
å
BB
8E
These surfaces
should be even.
BB
Surface with
CORNER ACCENT
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Page 12
SILVER 5/8" MACHINE SCREW
(2 used for the PULLS)
AA
These surfaces
should be even.
Z
B
Start
Arrow
15S
These surfaces
should be even.
A
Z
Tighten
Maximum
210 degrees
Minimum
190 degrees
415572
Surface with
CORNER ACCENT
AA
Arrow
www.sauder.com/services