Sauder Carson Forge Serie Manual Del Usuario página 22

Step 16
Carefully stand your unit upright.
å
Before fastening the DOORS to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten one of the DOORS (L) and the GLASS DOOR (K) to
å
the LEFT END (B) and LEFT UPRIGHT D). Use the screws
in the HINGES. You should start each SCREW a few turns
before completely tightening any of them.
Fasten two KNOBS (52K) to the DOORS (L and K). Use
å
two BLACK 1-1/8" MACHINE SCREWS (21S).
Insert a DOOR STOP (4I) into the hole in UPRIGHT (C).
å
Repeat this step for the other DOOR (L).
å
See the next step for DOOR adjustments.
å
L
52K
52K
21S
BLACK 1-1/8" MACHINE SCREW
(3 used in this step)
Page 22
B
K
14H
Hinge
D
C
4I
415572
Stop
Mounting
screw
Stop
40H
Mounting
screw
Hinge
www.sauder.com/services