Sauder Carson Forge Serie Manual Del Usuario página 18

Step 12
Carefully turn the unit over onto its front edges. Unfold the LARGE BACK (G). Lay the LARGE BACK (G) and the SMALL
å
BACKS (H) over the unit. Nail the BACKS (G and H) to the unit along the edges of the TOP (E), BOTTOM (F), ENDS (A
and B) and UPRIGHTS (C and D). Use sixty-six NAILS (1N).
NOTE: Be sure to tap the NAILS (1N) into the holes that line up over the UPRIGHTS (C and D).
å
NOTE: The backs will overlap each other along the edges of the UPRIGHTS (C and D).
å
NOTE: Perforations have been provided for access through the BACKS (G and H). Carefully cut out the holes needed.
å
Fasten the FOOT BRACKETS (6E) to the BOTTOM (F). Use six BLACK 9/16" LARGE HEAD SCREWS (1S).
å
Slide the SUPPORT FEET (FF) onto the FOOT BRACKETS (6E).
å
Firmly push the CORNER CAPS (5E) onto the SUPPORT FEET (FF).
å
These perforated
holes must be here.
5E
FF
6E
Page 18
E
A
H
G
6E
F
5E
FF
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(66 used in this step)
These holes must line
up over the UPRIGHTS.
H
6E
BLACK 9/16" LARGE HEAD SCREW
(6 used for the FOOT BRACKETS)
415572
Caution
1N
B
1S
www.sauder.com/services