Sauder Carson Forge Serie Manual Del Usuario página 24

Step 18
1
D20
U
Groove
Insert the DRAWER SIDES (D20 and D21) at an angle
å
into the slot at each end of the CENTER DRAWER
FRONT (U).
3
U
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (I) to the CENTER
å
DRAWER FRONT (U). Tighten one HIDDEN CAM.
Page 24
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D21
Maximum
Arrow
210 degrees
Minimum
190 degrees
I
VIEW THE T-LOCK BOX VIDEO
2
D20
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D733) into the grooves
å
in the DRAWER SIDES (D20 and D21) and CENTER
DRAWER FRONT (U).
4
D169
D20
I
Fasten the DRAWER BACK (D169) to the DRAWER SIDES (D20
å
and D21) and DRAWER BRACE (I). Use five BLACK 1-9/16" FLAT
HEAD SCREWS (30S). Repeat this step for the other drawers
using RIGHT DRAWER FRONT (S), LEFT DRAWER FRONT (T),
DRAWER BACK (D63) and DRAWER BOTTOM (D968).
NOTE: These two drawers do not have DRAWER BRACES (I).
415572
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D733
U n
fi n
s u
i s h
r f a
e d
c e
U
D21
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(13 used in this step)
Be sure the
DRAWER
BOTTOM
D21
inserts into
the DRAWER
BACK groove.
www.sauder.com/services