Fuel Filter Cartridge Replacement; Engine Oil; Checking Oil Level And Adding Engine Oil - KUBOTA D1105-TE3 Manual Del Operador

Mototr diesel
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 262
BFuel filter cartridge replacement
1. Replace the fuel filter cartridge with a new one every
400 operating hours.
2. Apply fuel oil thinly over the gasket and tighten the
cartridge into position by hand-tightening only.
3. Finally, vent the air.
A Replace the fuel filter cartridge periodically to
prevent wear of the fuel injection pump plunger or
the injection nozzle, due to dirt in the fuel.
(1) Fuel filter cartridge
(2) Air vent plug
(3) O ring
(4) Pipe joint
(5) Cover

ENGINE OIL

CAUTION
To avoid personal injury:
A Be sure to stop the engine before
checking and changing the engine
oil and the oil filter cartridge.
A Do not touch muffler or exhaust pipes
while they are hot; Severe burns
could result. Always stop the engine
and allow it to cool before conducting
inspections, maintenance, or for a
cleaning procedure.
A Contact with engine oil can damage
your skin. Put on gloves when using
engine oil. If you come in contact
with
engine
immediately.
A Be sure to inspect the engine, locating it on a level
place. If placed on gradients accurately, oil quantity
may not be measured.
oil,
wash
it
off
PERIODIC SERVICE
BChecking oil level and adding engine oil
1. Check the engine oil level before starting or more
than 5 minutes after stopping the engine.
2. Remove the oil level gauge, wipe it clean and
reinstall it.
3. Take the oil level gauge out again, and check the oil
level.
1ABABAAAP148A
(1) Oil filler plug
(2) Oil level gauge
15
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

D1005-e3V1505-e3D1105-e3D1305-e3V1505-te3

Tabla de contenido