Publicidad
PROBLEM
POSSIBLE CAUSE
Dust escaping from vacuum
1. Dirt cup full.
2. Dirt cup not installed correctly.
3. Rinsable filter and/or separator not installed completely.
4. Filter is dirty
Vacuum tools won't pick up
1. Dirt cup full.
2. Filter is clogged.
3. Power carpet nozzle not spinning.
Poor suction
1. Dirt cup not seated completely.
2. Filter is clogged or dirty.
3. Dirt cup not installed correctly.
4. Battery charge is getting weak.
5. Nozzle/dirt passage clogged.
Vacuum running warm
1. Dirty filter.
2. Low suction.
Vacuum won't turn ON
1. Battery is not charged.
or charge
2. Your battery may be too hot.
POSSIBLE SOLUTION
1. Empty dirt cup. (see page 16)
2. Review dirt cup removal and replacement. (see page 17)
3. Review filter removal and cleaning. (see page 17)
4. Rinse Filter
1. Empty dirt cup. (see page 16)
2. Remove filter and clean. (see page 17)
3. Remove and reattach. (see page 18)
1. Reinstall dirt cup, make sure lid is closed completely. (see page 17)
2. Remove filter and clean. (see page 17)
3. Review filter removal and replacement. (see page 17)
4. Charge battery. (see page 10)
5. Turn off the unit and then disconnect the nozzle to remove
debris. (see page 18)
1. Clean filter, rinse, dry and re-assemble. (see page 17)
2. Locate clog and remove.
1. Charge battery. (see page 10)
2. Let the vacuum cool for 30 minutes and retry.
HARD
BOOST
FLOOR
MODE
19
Publicidad
