Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75888F
Wrenches: 14mm,17mm, ¾"
Drill Bits: None
Note: All Fasteners Typical Both Sides of Vehicle.
j
Hex Bolt – M10 x 1.25 X 40mm CL8.8
Qty. (2)
k
Conical Toothed Washer – 3/8"
Qty. (2)
l
Qty. (4)
Carriage Bolt– 1/2-13 X 4-1/2 GR5
Removal of spare tire will make installation easier.
1.
Lower exhaust by disconnecting (3) rubber exhaust hangers from muffler.
2.
Remove tow hook from driver side vehicle frame. Return tow hook & fasteners to owner.
3.
Raise hitch into position, install all fasteners as shown.
4.
Raise exhaust back into position by re-connecting rubber exhaust hangers (re-attach muffler to exhaust pipe if removed in step 1).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
©
2014 Cequent Performance Products – Printed in México
Installation Instructions
Mitsubishi Outlander
(Except Sport)
Plastic Fascia
Tighten all M10 x 1.25 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3, SUV4
Existing Weldnut
Vehicle Frame
l
k
m
Flanged Lock Nut – 1/2-13
Qty. (4)
n
Hardened Flat Washer 1/2"
Qty. (4)
Sheet 1 of 3
75888N
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
4000 (1816 Kg.)
4000 (1816 Kg.)
Accessory Rating
n
j
1/20/2014
75888
44707
87656
Max Tongue
WT (LB)
600 (272 Kg.)
600 (272 Kg.)
C
m
Rev. X1
Form: F205 Rev A 5-6-05