Cequent Performance Products 75876 Instrucciones De Instalación

ACCESS HOLE
Hitch Shown In Proper Position
Equipment Required: Metal File
Fastener Kit: 75876F
Wrenches: 11/16", 10mm
j
Carriage Bolt – 7/16-14 x 1.75 GR5
Qty. (6)
k
Spacer (Square hole for 7/16" Carriage Bolt)
Qty. (6)
l
Conical Washer – 7/16"
Qty. (6)
1. Lower exhaust by disconnecting rubber exhaust hanger(s) from hanger bracket(s).
2. Remove (4) heat shield screws from eachframe rail and set aside.
Note: When hitch is installed, heat shield will need to be trimmed for bolt clearance (see Figure 2) to fit in position.
3. Remove (4) plastic plugs from existing holes in each frame rail keeping only the rear access hole plug for reinstallation after bolts are in place.
Fishwire spacers and 7/16" carriage bolts thru access hole and down thru holes in both frame rails, making sure
4.
blocks span both sides of hole and are not overlapping one another. (see figures 1 & 3)
5. Reinstall trimmed heat shield and 3 of the 4 fasteners removed in Step 2, leaving out the rearmost fastener on the frame rail.
6. Raise hitch into position, being careful not to push fasteners into frame, and secure with conical washers and nuts.
7. Raise exhaust back into position and reinstall exhaust hangers disconnected in Step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
© 2015 Cequent Performance Products, Inc. – Printed in Mexico
Installation Instructions
Subaru Forester
Fascia
Fasteners Typical Both Sides
ACCESS HOLE
Figure 1
Tighten 7/16-14 GR5 fasteners to 50 lb.-ft. (68 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV8
j
k
ACCESS HOLE
l
m
m
Hex Nut – 7-16-14
Qty. (6)
n
Pull Wire – 7/16"
Qty. (6)
Sheet 1 of 3 75876N
Part Numbers:
75876
87654
44705
Max Gross
Trailer WT (LB)
4000 Lb (1816 Kg) 525 Lb (238 Kg)
3500 Lb (1589 Kg) 525 Lb (238 Kg)
Accessory Rating
Figure 2: TRIM HEAT SHEILD AS
SHOWN TO CLEAR BOLTS.
Figure 3: Kink pull wire to keep
Spacer independent of bolt
1/6/15
Form F206 Rev A 5605
Max Tongue
WT (LB)
C
TRIM
Rev. B