Yakima LoadWarrior Extension Guia De Inicio Rapido página 2

IF YOU ALREADY HAVE A
LOADWARRIOR
INSTALLED:
• Remove it from your car.
• Disassemble the brackets
and set them aside.
• Separate the two basket
halves by removing the
screws at the joints.
•IF YOU HAVE FIXED BARS:
IF YOU HAVE "Q TOWERS"
OR BARS THAT CANNOT MOVE...
Continue to STEP
Q TOWER OWNERS:
NEVER REPOSITION THE Q TOWERS!
LOAD BASKET ONTO RACKS.
Center basket over your rack's
crossbars.
ATTACH BOLTS AND KNOBS.
Insert bolts, engage the knobs.
Remove the machine screws from
the ends of the Extension tubes.
• Insert the LoadWarrior Extension.
NOTE: Always replace
machine screws (from Extension) into
same holes when reassembling.
.
ATTACH BRACKETS TO BASKET SECTIONS ONLY.
For first time bracket installation, refer to LoadWarrior instructions.
A friend
would make
this easier .
SECURE THE BASKET TO
THE BARS.
Lock the T-Bolts.
You may find tapered screws
with your LoadWarrior.
MACHINE
SCREWS
DO NOT insert the tapered screws
from LoadWarrior into your
Extension's holes.
•IF YOUR BARS MOVE:
IF YOU HAVE BARS THAT CAN BE MOVED...
Move the bars apart to a range of 30" to 50".
TIGHTEN YOUR CROSSBARS
IF YOU LOOSENED THEM.
(SIDE VIEW)
T-BOLT IS LOCKED when the
"T" of the bolt is turned
inside the hole:
Insert correct
screws into
each of the
TAPERED
joints and
SCREWS
tighten them.
TIGHTEN
THE KNOBS.