Yakima LoadWarrior Extension Guia De Inicio Rapido página 3

ATTACH LOAD BAR WITH END CLAMPS.
With a washer on the bolt, align the end
clamps to the hole in the bar. Thread the
bolts into the embedded nuts.
DO NOT COVER
JOINT SCREWS WITH END
CLAMPS.
ACCESSORIES MUST BE ATTACHED TO THE FRONT OF THE BASKET (FRONT OF VEHICLE).
BIKES
• Attach carrier at front of basket
and to load bar.
• Adjust the bar for load stability.
Upright carrier
utilizing LoadBar
Fork style carrier
utilizing LoadBar
ALWAYS TIE
DOWN LONG
LOADS TO FRONT
AND REAR OF
VEHICLE.
BOATS
• For shorter boats, attach accessory at front of
basket and to load bar.
• Longer loads, such as canoes or sea kayaks,
require the load bar to be removed.
Long loads may interfere
with LoadBar
REFER TO THE DRAWINGS BELOW
FOR BAR PLACEMENT, or to
determine if the bar is required.
Tighten bolts while
pushing the end
clamps together.
SKIS
• Attach accessory at front of
basket and to load bar.
Short boat
utilizing LoadBar
USE CAUTION WHEN
OPENING YOUR HATCH.
On some vehicles, hatch
interference is unavoidable.